Found the problem, the connector which you push the ESC into which connects it to the PDB had snapped off and was only holding on by a thread. After days of trying to swap ESC and motors I decided to pull the entire quad apart. They eventually arrived, replaced them on quad and was hovering for about 10 seconds then the quad would fall out of the air. I crashed my F210 3 months ago, cracked a leg in 1/2 and bent the ESC so it looked like a boomerang. That is what I did to bind a new and modified profile to my F210, hope this helps you, post me if you need more info Turn on the RC and immediately (2 seconds or so) connect the battery to the F210, the binding process will begin and take around 10 seconds Have the F210 near you ready to connect the battery.ġ0). Turn on your RC and select the profile for the F210, ensure that "Fixed" binding is switched off, ( see other video links from my earlier posts ), then turn off the RC.ĩ). You can now release the "Clear" button, and disconnect the drone battery.Ĩ). After 5 seconds or so, with the battery still connected, release the "Clear" button, the Red LED will then start to flash quickly.ħ). You will see the Red LED to the left of the "Clear" button start to flash slowly,Ħ). With battery disconnected press and hold the "clear" button, and then connect the battery with the button still pressed.ĥ). From my picture you can see the "Clear" button that I point to with the pen, ( in other post this has the same function as the "Bind" plug )Ĥ). You will see towards the nose of the drone a small square circuit board ( the RX713 reciever) with 2 antenna cables attached to it.ģ). With the battery disconnected, remove the 4 screws which hold the (boat shaped) access plate from the underside of the F210.Ģ). Sorry about the delay, here is how I managed to bind the Walkera F210 to another profile in the Devo7 RC, I think this will be the same for a new profile or for a new RC i.e Devo10ġ).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |